Not connected

Temperature & barometer

Body temperature is stored in the same on-device log as SpO2, so it comes down over the encrypted activity-fetch endpoint 0x004b — only the data-type byte differs. The exact id changes between firmwares, so we probe a shortlist and keep the first one the watch accepts. The barometer has no documented BLE command; the probe below sends the usual get sub-commands to every endpoint we have not identified yet and reports any reply that decodes to a plausible pressure or altitude.

Body temperature

Connect with a valid auth key first.

Live squad telemetry (Zepp OS mini-app)

The sensors are only reachable from inside the watch, so a small Zepp OS app reads heart rate, SpO2, steps, calories, distance, GPS, stress and @zos/sensor.Barometer every few seconds and relays them through the Zepp phone app to this dashboard — no workout needed. Every watch that uses the same pairing code shows up here as its own operator. Source and build instructions live in the zepp-app/ folder of this project.

Heart rate
—
waiting for watch
SpO2
—
last watch reading
Pressure
—
barometer
Altitude
—
watch altimeter
Steps
—
today
Distance
—
today
Position
—
watch GPS
Battery / stress
—
watch battery
Temperature
—
body / wrist temp
Accelerometer
—
x, y, z
Gyroscope
—
x, y, z °/s
GPS status
—
reported by watch
0 sample(s)

Barometric altitude (workout tracks)

Zepp OS has no barometer BLE endpoint — but the altimeter reading is written into every recorded workout track as record type 7 of the sports-details stream (fetch type 0x06 over the encrypted 0x004b channel). On newer firmware that value is the barometric altitude in 0.01 mm units, so it is the real sensor, not GPS. From altitude we can invert the standard-atmosphere formula to get pressure.

Barometer / altimeter

Raw byte scanning finds hundreds of coincidental matches, so the probe runs twice and keeps only slots that answer with the same value both times. Type both the pressure and the altitude your watch shows right now: a reply that carries both at once is the real barometer frame. The probe also looks for history-shaped runs (the graph on the watch).

Sends 0x03 / 0x01 / 0x05 / 0x02 / 0x07 to every unidentified endpoint, twice. Takes a few seconds.